A special device available for club builders can measure the stiffness of an orifice through a so-called hollow frequency measurement. 토토사이트 With the end of the head when testing the raw rod or the head attached at the end. The creator of the club pulls the cart down, lets it out, and the well begins to push up and down.
Frequency matching stiffer nearby, faster oscillation rate; The more flexible the shaft, the slower the rate of oscillation. The frequency analyzer is designed to count the oscillation rate of the axis and display the reading in the form of cycles per minute numerical value on the LED screen on the machine.
In a wooden or metal set, the club frequency reading will increase from the longest club to the shortest club. However, due to many factors, the amount of increase from the axis to the well is not usually at the same level.
Some custom club founders provide axial repair services when installed at the club, so increasing the frequency from the longest club to the shortest club in the set will be the same between club and club. This is a frequent match.
Frequency matching will deepen the evolution of club-to-club capture from the longest club to the shortest club in a player’s pocket. But if the weight of the shaft shoft flex and bend profile does not fit the golfer, then frequency matching will not help the player.
It is more important to fill the weight of the liner and bend to the golfer than to worry about frequency matching, otherwise it will match.